Leon Mk2
| Fuel tank, vehicles with front wheel drive installation overview |
| 1 - | 40 Nm |
| q | Replace. |
| q | Lubricate studs of exhaust manifold with high-temperature lubricant. |
| 2 - | Catalytic converter with primary exhaust pipe |
| q | Protect from damage by knocks and impact |
| q | With flexible connection (de-coupling element) |
| q | Do not bend flexible connection more than 10°. It may be damaged |
| q | Removing and fitting → Chapter |
| q | Fit and align exhaust system free of stress → Chapter. |
| 3 - | Lambda probe after catalytic converter -G130- - 55 Nm |
| q | Apply high-temperature lubricant to thread only. The fluid must not get into the slots on the probe body |
| 4 - | Mounting |
| q | Replace if damaged |
| 5 - | 25 Nm |
| 6 - | Secondary silencer |
| q | Factory Silencer executed with center as a component. In case of repair individually replaceable |
| q | Fit and align exhaust system free of stress → Chapter. |
| q | Remove the exhaust system → Chapter |
| 7 - | Suspension |
| q | Replace if damaged |
| 8 - | 25 Nm |
| 9 - | Rear clamp |
| q | For separate replacement of centre and rear silencers |
| q | installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 10 - | Middle silencer |
| q | Factory Silencer executed with center as a component. In case of repair individually replaceable |
| q | Fit and align exhaust system free of stress → Chapter. |
| q | Remove the exhaust system → Chapter |
| 11 - | 25 Nm |
| 12 - | Front clamp |
| q | Align exhaust system so it is free of stress before tightening clamp → Chapter |
| q | installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 13 - | 25 Nm |
| 14 - | Exhaust system bracket |
| 15 - | Suspension |
| 16 - | Shutter |
| q | Replace. |
| 17 - | Lambda probe -G39- 55 Nm |
| q | Apply high-temperature lubricant to thread only. The fluid must not get into the slots on the probe body |
|
|
|
|
