–
| Remove the lambda probe-arrow- by unscrewing with a tool from the set of ring spanners for lambda probes -3337-. |
When fitting, note the following: |
Note t
| The screw thread on the new lambda probe is coated with a special paste; the paste must not get into the slots on the probe body. |
t
| With used lambda probes, heat the bolt before coating with paste. This paste must not get into the slots on the hot bolt paste → Spare parts catalogue |
t
| When assembling, the lambda probe cable must be fixed in its original position to avoid contact with the exhaust pipe. |
l
| Tightening torque: 55 Nm. |
|
|
|