Measure radial play for crankshaft |
Special tools and workshop equipment required |
Note t
| Do not interchange used bearing shells. |
t
| Bearing shells that have been worn down to the nickel layer must be replaced. |
–
| Remove the crankshaft bearing caps then clean the bearing caps and supports. |
–
| Place the Plastigage thread the same with of the bearing on to the journal or the half bearing. |
l
| The Plastigage thread should remain in the centre of the half bearing. |
–
| Fit the bearing cap and tighten to 65 Nm without rotating the crankshaft. |
–
| Remove the bearing caps once more. |
–
| Check the width of the Plastigage thread against the measurement scale. |
l
| new: 0,017 ... 0.037 mm |
|
|
|