Leon Mk2
|
WARNING
| 1 - | Cylinder 1 injector -N30- up to cylinder 4 injector -N33- |
| q | Removing and installing → Chapter |
| 2 - | 8 Nm |
| 3 - | Fuel rail |
| q | Removing and installing → Chapter |
| 4 - | Low pressure fuel hose |
| q | To high-pressure pump. |
| 5 - | Pressure limiting valve |
| q | 30 Nm |
| q | Removal and installation involves removing the intake manifold → Chapter |
| 6 - | Speed nut |
| 7 - | Low-pressure line |
| q | Counterhold when loosening the union nut of the pressure relief valve. |
| q | Before installing, check the tightening torque of the pressure relief valve |
| q | Do not fit under stress |
| q | Tighten union nuts to 22 Nm |
| 8 - | Spring retainer |
| 9 - | High-pressure pipe |
| q | When loosening, counterhold the union nut of the threaded connection |
| q | Before installing, check the tightening torque of the threaded connection |
| q | Do not fit under stress |
| q | Tighten union nuts to 27 Nm |
| 10 - | 3 Nm |
| 11 - | Electrical connector |
| q | For injectors |
| 12 - | Electrical connector |
| q | For → Item and → Item |
| 13 - | Electrical connector |
| q | For → Item |
| 14 - | Cable spacer |
| 15 - | Clip |
| q | Mount at the bottom right on the hose of the intake manifold |
| 16 - | Electrical connector |
| q | for Hall sender -G40- |
| 17 - | Electrical connector |
| q | For fuel pressure sender -G247- |
| 18 - | 5 Nm |
| 19 - | Fuel pressure sender -G247- |
| q | 22 Nm |
| q | Lubricate threads and taper seat with clean engine oil |
| q | Removing and installing → Chapter |
| q | Checking → Chapter |
| 20 - | Union |
| q | 30 Nm |
