Leon Mk2
Assembly overview - coolant pump and thermostat |
1 - | Bolt. |
q | 9 Nm |
q | Tightening sequence → Fig. |
2 - | O-ring |
q | Replace |
3 - | Connecting piece |
4 - | Retaining clip |
q | Only on clip-on version |
q | Check for secure seating. |
5 - | Bolt. |
q | 4 Nm |
q | Only on bolted version |
6 - | Retaining plate |
q | Only on bolted version |
7 - | Coolant temperature sender -G62- |
q | Removing and installing → Chapter |
8 - | O ring |
q | Replace |
9 - | Coolant pump |
q | Removing and installing → Chapter |
q | If the coolant pump is new, remove the cap |
10 - | Seal |
q | Replace |
11 - | Centring bolt |
q | 2 units |
12 - | Notched belt |
q | For coolant pump |
q | Removing and installing → Chapter |
13 - | Timing belt cover |
14 - | Bolt. |
q | 9 Nm |
15 - | Bolt. |
q | Left-hand thread. |
q | 10 Nm + further 1/4 (90°) |
q | Replace |
16 - | Ribbed belt drive pinion |
q | Note fitting position: |
17 - | Oil seal |
q | Replace → Chapter |
18 - | Balancing shaft |
19 - | Coolant thermostat: |
q | Removing and installing → Chapter |
20 - | Centring pin |
21 - | O ring |
q | Replace |
22 - | Joint mouth |
23 - | Bolt. |
q | 9 Nm |
|