SEAT Workshop Service and Repair Manuals

Removing and installing coolant temperature sender -G62- Removing → Anchor. Installing → Anchor.

Removing Proceed as follows: l  Engine cold. –  Remove the air conduit cover by releasing the side tabs -arrows-.

–  Release the lower air conduit by releasing the tabs -arrows-. –  Detach bottom section of air duct with air hose.

–  Remove the air conduit guard -Pos. 2 and 3-.   Note Ignore positions -1 and 2- and the -arrow-.

–  Disconnect electrical connection -1- on throttle valve control unit -J338-. –  Unscrew the bolts -arrow- and remove the throttle valve control unit -J338-.

–  Remove support for intake manifold (remove nut -2- and bolt -1-).

Clip-on version –  Disconnect connector -1- from coolant temperature sensor -G62-.   Note Place a cloth below to catch escaping coolant. –  Detach retaining clip (press release tabs -arrows-). –  Remove the coolant temperature sender -G62--pos. 2-.

Bolted version –  Disconnect connector -2- from coolant temperature sensor -G62-.   Note Place a cloth below to catch escaping coolant. –  Unscrew the bolts -arrows- and remove the retention plate -1-. –  Coolant temperature sender -G62-: Remove Installing Reassembly is carried out in the reverse order; note the following:   Note t  Renew O-ring. t  Insert new coolant temperature sender -G62- immediately into connection to avoid loss of coolant. –  Fit intake manifold support → Item –  Replace the throttle valve control unit -J338-. –  Fill up coolant → Chapter.