–
| Apply a line of silicon sealant, as shown in the figure, to the clean surface of the frame seal. |
t
| Thickness of the sealant grub: 2 to 3 mm. |
Note t
| The sealing flange must be installed within 5 minutes of applying silicone sealant. |
t
| The bead of sealant must not be thicker than specified, otherwise excess sealant can enter the sump and obstruct the strainer in the oil intake pipe. |
–
| Fit the sealing flange immediately and tighten bolts in the sequence → Fig. |
Note After fitting the sealing flange, the sealant must be left to dry for 30 minutes. Only then should the engine be refilled with oil. |
The remaining installation steps are carried out in the reverse sequence. Note the following: |
|
|
|