| Parts of the exhaust system: Removing and installing |
Note | t
| The connecting elements of the front exhaust pipes must not be bent more than 10°, otherwise they could be damaged. |
| t
| Always gaskets and self-locking nuts. |
| t
| After completing work on the exhaust system ensure that it is tension-free and remains at a sufficient distance from the bodywork. If necessary, loosen the clamping bracket and align the silencer with exhaust pipe so that there is always a sufficient clearance from the bodywork and is evenly distributed over the suspension elements. |
| t
| The exhaust manifold and the turbocharger make up a single part, removing and fitting → Chapter. |
| Fuel tank, vehicles with front wheel drive installation overview → Chapter |
| Exhaust system -vehicles with four-wheel drive: Assembly overview → Chapter |
| Exhaust system - Assembly overview (engine codes CDAA, CCZB) → Chapter |
| Separating centre and rear silencers → Chapter |
| Exhaust pipe with catalytic converter: Removing and installing → Chapter. |
| Fit and align exhaust system free of stress → Chapter. |
| Removing and installing Lambda probe -G39- and Lambda probe heater -Z19- before catalytic converter → Chapter |
|
|
|
