Leon Mk2
| Exhaust system - Assembly overview (engine codes CDAA, CCZB) |
| 1 - | Nut |
| q | 40 Nm |
| q | Replace |
| q | Coat studs of turbocharger with high-temperature paste. |
| q | High-temperature paste → Parts catalogue |
| 2 - | Lambda probe -G39- and Lambda probe heater -Z19- |
| q | Cylinder bank 1, probe 1 |
| q | 52 Nm |
| q | The thread should only be lubricated with a high temperature thread lubricant; the paste should not penetrate the grooves on the body of the probe |
| q | High-temperature paste → Parts catalogue |
| q | Removing and installing → Chapter |
| 3 - | Front exhaust pipe with catalytic converters |
Caution
|
| q | Protect catalytic converter from damage by knocks and impact |
| q | Removing and installing → Chapter |
| q | Align exhaust system so it is free of stress → Chapter. |
| 4 - | Lambda probe, after catalytic converter -G130- and Lambda probe heater 1, after catalytic converter -Z29- |
| q | Cylinder bank 1, probe 2 |
| q | 52 Nm |
| q | The thread should only be lubricated with a high temperature thread lubricant; the paste should not penetrate the grooves on the body of the probe |
| q | High-temperature paste → Parts catalogue |
| q | Removing and installing → Chapter |
| 5 - | Holder |
| q | Replace if damaged |
| 6 - | Middle silencer |
| q | Centre silencer and rear silencer are one unit as original equipment. Can be renewed separately for repair purposes |
| 7 - | Holder |
| q | Replace if damaged |
| 8 - | Secondary silencer |
| q | Factory Silencer executed with center as a component. In case of repair individually replaceable |
| 9 - | Holder |
| q | Replace if damaged |
| 10 - | Securing bolt |
| q | 25 Nm |
| 11 - | Nut |
| q | 25 Nm |
| 12 - | 25 Nm |
| 13 - | Clamp |
| q | Installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 14 - | Nut |
| q | 25 Nm |
| 15 - | Securing bolt |
| q | 25 Nm |
| 16 - | Suspension |
| q | Replace if damaged |
| 17 - | Seal |
| q | Replace |
