Leon Mk2
Exhaust system, vehicles with all-wheel drive - Installation survey |
1 - | Middle silencer |
q | Mounting unit with rear silencer |
q | Stress-free alignment of exhaust system → Chapter |
2 - | Holder |
q | Replace if damaged |
3 - | Bolt. |
q | 23 Nm |
4 - | Bracket for exhaust system |
5 - | Bolt. |
q | 23 Nm |
6 - | Suspension |
q | Replace if damaged |
7 - | Seal |
q | Replace |
8 - | Nut |
q | 40 Nm |
q | Replace |
q | Coat studs of turbocharger with high-temperature paste. |
q | High-temperature paste → Parts catalogue |
9 - | Lambda probe -G39- and Lambda probe heater -Z19- |
q | 52 Nm |
q | The thread should only be lubricated with a high temperature thread lubricant; the paste should not penetrate the grooves on the body of the probe |
q | High-temperature paste → Parts catalogue |
q | Removing and installing → Chapter |
10 - | Front exhaust pipe with catalytic converter |
q | Do not bend flexible connection more than 10°, you may damage it |
q | Do not load the release element by pulling on it. |
q | Do not damage the cable of the release element. |
q | Protect catalytic converter from damage by knocks and impact |
q | Removing and installing → Chapter |
q | Stress-free alignment of exhaust system → Chapter |
11 - | Lambda probe, after catalytic converter -G130- and Lambda probe heater 1, after catalytic converter -Z29- |
q | 52 Nm |
q | The thread should only be lubricated with a high temperature thread lubricant; the paste should not penetrate the grooves on the body of the probe |
q | High-temperature paste → Parts catalogue |
q | Removing and installing → Chapter |
12 - | Clamp |
q | Align exhaust system so it is free of stress before tightening clamp → Chapter |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
13 - | Nut |
q | 23 Nm |
q | Replace |
14 - | Suspension |
q | Replace if damaged |
15 - | Bolt. |
q | 25 Nm |
16 - | Secondary silencer |
q | Forms, together with the central silencer, one single unit |
q | Stress-free alignment of exhaust system → Chapter |
17 - | Holder |
q | Replace if damaged |
18 - | Bracket for exhaust system |
19 - | Bolt. |
q | 23 Nm |
20 - | Bracket for exhaust system |
21 - | Bolt. |
q | 23 Nm |
22 - | Holder |
q | Replace if damaged |
|