seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Active charcoal tank system > < Assembly overview - accelerator module

Leon Mk2

Removing and installing accelerator module
Removing and installing accelerator module
Removing → Anchor.
Installing → Anchor.
Special tools and workshop equipment required
   
t  For left-hand drive vehicles: Release tool -T10238-, see equivalent → Anchor
  W00-10110
t  For right-hand drive vehicles: Release tool -T10240-, see equivalent → Anchor
Removing
  W00-10108
–  Remove the steering column cover -arrows-.
–  Prise off the cap → Item using a screwdriver.
–  Remove the securing bolt → Item.
  A20-1085
–  Push release tool -T10238- (for right-hand drive vehicles release tool -T10240-) into intended holes as shown to stop and remove accelerator module.
–  Disconnect the connector, and remove the wiring of the accelerator pedal module.
  N20-10056
Installing
–  Push wiring guide -1- and electrical connector -2- onto accelerator module.
–  Insert the accelerator pedal module onto the attachment bolts -6-.
–  Insert the centring pin -7- into the hole in the vehicle floor.
–  Secure accelerator module with bolt -3-, specified torque 10 Nm and install cap -4-.
–  Place the steering column cover back on.
  A20-1088

Active charcoal tank system > < Assembly overview - accelerator module