Leon Mk2
|
WARNING
| 1 - | Thrust piece |
| q | In certain circumstances, this may be left in the cylinder head after dismounting the high pressure pump, but may also be removed. |
| 2 - | O ring |
| q | Replace |
| 3 - | Single piston high pressure pump |
| q | In the fuel tank there is an electric fuel pump which sends fuel with a pressure of around 7 bar to the high pressure pump. |
| q | When fitting the high pressure pump, take care that no dirt enters the fuel system. |
| q | The fuel system must not be under any pressure; eliminate all pressure → Chapter |
| q | The fuel pipes must not be under tension when fitting them |
| q | Removing and installing → Chapter |
| 4 - | Fuel pressure regulating valve -N276- |
| 5 - | Cylinder head gap for high-pressure pump |
| 6 - | Injectors |
| q | Renew O-rings. |
| q | Ensure correct installation position |
| q | Removing and installing → Chapter |
| 7 - | Hall sender -G40- |
| 8 - | Camshaft control valve 1 -N205- |
| 9 - | Bolts for high-pressure pump |
| q | Replace |
| q | 10 Nm |
| 10 - | Connection hose for the fuel supply pipe, from the tank |
| 11 - | Connection hose for the fuel supply pipe to the fuel rail (common rail) |
| q | Replace |
| q | Joint mouth: 22 Nm |
| q | Tightening torque for union nut for fuel supply pipe: 18 Nm |
| q | Fuel supply pipe must be free of tension when installed (make sure all parts are clean) |
