SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Assembly overview - air filter >
< Engine cover: Removing and installing (engine codes BZB - CDAA - CCZB)
Leon Mk2
Power unit
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain)
Mixture preparation system, electronic inj.,Gas / Injection system
Cover with oil separator: Removing and installing (engine code BYT)
Cover with oil separator: Removing and installing (engine code BYT)
Cover with oil separator: Removing and installing (engine code BYT)
Oil separator is fitted in cover only on engine with code letters BYT.
Vehicles with engine codes BZB - CDAA - CCZB
→ Fig.
Removing
→ Anchor
.
Installing
→ Anchor
.
Special tools and workshop equipment required
t
Extractor -T40039-, see equivalent
→ Anchor
Removing
–
Carefully remove engine cover
→ Chapter
.
–
Carefully extract the hose
-1-
.
–
Extract the vacuum hoses
-2-
,
-3-
,
-4-
and
-5-
.
–
Release the electrical connections
-arrows-
and disconnect all of the ignition coils at the same time.
–
Extract all the ignition coils from their housings using the extractor -T40039-.
–
Unscrew the oil filler cap
-arrow-
.
–
Unscrew the bolts
-1 to 6-
and remove the oil settling tank from the cylinder head cover.
–
Lift the cover towards the right and extract the vacuum pipe from both tabs
-arrows-
.
Installing
–
Note the O-ring
-arrow-
; if it is damaged replace it.
–
Tighten the screws to 11 Nm in the following sequence
-1 ... 6-
.
–
Perform remaining installation in reverse order of removal.
Power unit
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain)
Mixture preparation system, electronic inj.,Gas / Injection system
Cover with oil separator: Removing and installing (engine code BYT)
Assembly overview - air filter >
< Engine cover: Removing and installing (engine codes BZB - CDAA - CCZB)