SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing radiator >
< Removing and installing thermostat
Leon Mk2
Power unit
4 cylinder Injection engine (1.4 l, 4 Direct injection valve, turbocharger and volumetric compressor)
Engine cooling / Parts of cooling system
Coolant fan V7 and Coolant fan -2V177: removing and fitting
Coolant fan V7 and Coolant fan -2V177: removing and fitting
Coolant fan -V7- and Coolant fan -2 -V177-: removing and fitting
t
Removing
→ Anchor
t
Installing
→ Anchor
t
Tightening torques
→ Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Torque wrench -VAG 1331-, see equivalent
→ Anchor
.
Removing
–
Place the lock carrier plate into service position
→ Bodywork, exterior fitting work; Rep. gr.50
–
Pull off intake hose
-1-
.
–
Unscrew securing bolts
-arrows-
and remove intake cowl.
–
Disconnect connector
-1-
.
–
Press the upper locking elements
-1-
on both sides to remove the air duct from the radiator. Take the duct out upwards
-arrow-
.
–
Remove air vent downwards.
–
Disconnect the electrical connection
-1-
, and set the cables aside.
–
Unscrew nuts
-arrows-
and remove fan.
Installing
Install in the reverse order to removal.
–
Fit the lock carrier assembly:
→ Bodywork, exterior fitting work; Rep. gr.50
.
Tightening torques
Components:
Nm
Radiator fan to cowling
10
Power unit
4 cylinder Injection engine (1.4 l, 4 Direct injection valve, turbocharger and volumetric compressor)
Engine cooling / Parts of cooling system
Coolant fan V7 and Coolant fan -2V177: removing and fitting
Removing and installing radiator >
< Removing and installing thermostat