–
| Use fitting tool -T20081B/1- and press guide sleeve-oil seal assembly until the oil seal is in place. To do this, use the old securing bolt for vibration damper. |
–
| Remove guide sleeve -T20081B/…-. |
–
| Fit the notched belt cogwheel. For this, immobilise it using the retention tool -T20018A- and tighten the new attachment bolt to the recommended torque → Item. |
Note The retightening angle may be measured using the angle measurement tool -T20030-. |
Fit the notched belt and adjust the distribution time → Chapter. |
|
|
|