SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing sealing flanges and flywheel or drive plate >
< Distribution housing: removing and fitting|Installation
Leon Mk2
Power unit
4 cylinder Injection engine (1.4 litre direct injection engine, turbocharger and chain control)
Enginecrankshaft group, pistons / Engine: assembly and dismantling
Removing and installing ancillary bracket
Removing and installing ancillary bracket
Removing and installing ancillary bracket
Special tools and workshop equipment required
t
Torque wrench -V.A.G 1331-
Removal:
–
Remove noise insulation.
–
Removing poly V-belt
→ Chapter
–
Remove alternator
→ Electrical system; Rep. gr.27
.
–
Remove air conditioner compressor
→ Heating, air conditioning; Rep. gr.87
Note
The air conditioning system lines must not be opened.
–
Secure air conditioner compressor to lock carrier.
–
Ensure that lines are not kinked.
–
Unscrew securing bolts
-1-
and remove bracket.
Installation
–
Fit ancillary bracket to cylinder block.
–
Tighten securing bolts
-1-
to 25 Nm.
Specified torque for tensioning element
→ Item
Further assembly is basically the reverse of the dismantling sequence.
Power unit
4 cylinder Injection engine (1.4 litre direct injection engine, turbocharger and chain control)
Enginecrankshaft group, pistons / Engine: assembly and dismantling
Removing and installing ancillary bracket
Removing and installing sealing flanges and flywheel or drive plate >
< Distribution housing: removing and fitting|Installation