SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Piston and cylinder dimensions >
< Check bore
Leon Mk2
Power unit
4 cylinder Injection engine (1.4 litre direct injection engine, turbocharger and chain control)
Enginecrankshaft group, pistons
Pistons and conrods
Separating new conrod
Separating new conrod
Separating new conrod
On new conrods it is possible that the breaking point is not fully separated. If it is not possible to take off the conrod bearing cap by hand, proceed as follows:
–
Mark cylinder allocation of conrod
→ Item
–
Gently clamp conrod, as shown in illustration, in a vice with soft aluminium jaws.
Note
t
Secure the conrod slowly so that it does not break.
t
The conrod is attached below the cutting line.
–
Unscrew the two bolts
-arrows-
. approx. 5 turns.
–
Using a plastic hammer, carefully knock conrod bearing cap loose in direction of
-arrow-
.
Power unit
4 cylinder Injection engine (1.4 litre direct injection engine, turbocharger and chain control)
Enginecrankshaft group, pistons
Pistons and conrods
Separating new conrod
Piston and cylinder dimensions >
< Check bore