SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder Injection engine (1.4 litre direct injection engine, turbocharger and chain control) | Exhaust system | Removing and installing parts of exhaust system | Separating exhaust pipe and front silencer

Separating exhaust pipe and front silencer

t	The exhaust pipe can be cut through at the point marked in order to renew the exhaust pipe or the front silencer separately.

t	The cutting point is marked by an indentation on the outside of the exhaust pipe.

Special tools and workshop equipment required

t	Chain pipe cutter -VAS 6254-

t	Pneumatic sabre saw -V.A.G 1523A-

Operation process

WARNING

To avoid injury from metal shavings, wear eye protection and protective clothing.

–	Cut through exhaust pipe at right angles at separating point -2- using pneumatic sabre saw -V.A.G 1523A- or chain-type pipe cutter -VAS 6254-.

–	Position repair double clamp at side marks -1- and -3- when installing.

–	Install double clamp so that bolt ends do not protrude beyond lower edge of double clamp -arrow-.

–	Align exhaust system free of stress.

Mounting position and specified torque of the clamping sleeve → Chapter

SEAT Workshop Service and Repair Manuals