seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fitting hose connections with plug-in connectors > < Charge air system

Leon Mk2

Supercharger air system - Assembly overview
Supercharger air system - Assembly overview
  Caution
The screw-type clips on the charge air pipes must be tightened to 5.5 Nm. If the torque is too low or too high, the charge air hose may slip off the charge air pipe during vehicle operation.
   
1 - Charge air cooler
q   Removing and installing → Chapter.
2 - 5 Nm
3 - Support
q   For charge air cooler.
4 - Seal
q   Replace if damaged
5 - Charge air hose
q   can be fixed with plug-in connectors or screw-type clips
6 - Hose for intake manifold
q   With seals.
7 - Throttle valve control mechanism -J338-
q   Clean → Chapter.
q   If renewed, erase learnt values and adapt engine control unit -J623- → Vehicle diagnostic tester„Guided functions“.
8 - 7 Nm
9 - Hose clip
10 - Charge air hose
11 - 10 Nm
12 - Charge air pipe
13 - Charge air pressure sender -G31- with intake air temperature sender 2 -G299-
14 - 5 Nm
15 - Charge air hose
q   To turbocharger
16 - Charge air pipe
17 - Charge air hose
q   can be fixed with plug-in connectors or screw-type clips

   

Fitting hose connections with plug-in connectors > < Charge air system