Leon Mk2
Part II: |
1 - | 8 Nm |
2 - | Coolant pipe |
3 - | O ring |
q | Replace |
4 - | Turbocharger |
q | Stud tightening torque: 20 Nm |
q | Removing and installing → Chapter. |
q | Checking turbocharger vacuum unit → Chapter. |
q | Removing and installing vacuum unit for turbocharger → Chapter. |
q | Adjusting vacuum unit for turbocharger → Chapter. |
5 - | Seal |
q | Replace |
6 - | Support |
Note
t | Retainer is discontinued. |
t | The retainer is not reinstalled in cases of repair. |
7 - | Support |
Note
t | Retainer is discontinued. |
t | The retainer is not reinstalled in cases of repair. |
8 - | 25 Nm |
Observe correct tightening sequence: Positions -A- to -I- |
9 - | Coolant pipe |
10 - | Seal |
q | Replace |
11 - | 8 Nm |
12 - | Oil return pipe |
13 - | Seal |
q | Replace |
14 - | Banjo bolt, 20 Nm |
q | Secured to valve timing housing. |
15 - | Oil supply pipe |
Caution
|
16 - | Banjo bolt, 30 Nm |