Leon Mk2
Fuel rail with injectors - Assembly overview |
1 - | O ring |
q | Replace |
q | Before installing moisten with clean engine oil |
2 - | Elastic element |
q | Renew each time after removing lower part of intake manifold. |
q | Ensure proper seating on injector. |
3 - | Injector, cylinder 4 -N33- |
q | Injector, cylinder 1 -N30- |
q | Injector, cylinder 2 -N31- |
q | Injector, cylinder 3 -N32- |
q | With Teflon seal and support washer. |
q | After removing injector, Teflon seal and support washer must be renewed → Chapter. |
q | Removing and installing injectors → Chapter. |
4 - | Intake manifold lower part |
Caution
|
q | To remove and install: using "bracket for bits 5/16""" -V.A.G 1766/2- and Bit -3320/2- → Fig. |
q | To remove, removing and installing regulating flap control unit -J808-, throttle valve module -J338- and intake manifold → Chapter. |
|