Leon Mk2
|
1 - | Joint mouth |
2 - | O ring |
q | Replace |
3 - | Compression spring |
4 - | Coolant temperature sender -G62- |
q | Before removing, release pressure in cooling system if necessary. |
5 - | Tappet |
q | Do not interchange when installing |
6 - | Retaining clip |
q | Check for secure seating. |
7 - | 10 Nm |
8 - | Thermostat housing |
9 - | Seal |
q | Replace |
10 - | To the heating system heat exchanger |
q | Coolant hose schematic diagram → Chapter |
11 - | From the heating system heat exchanger |
q | Coolant hose schematic diagram → Chapter |
12 - | Coolant pump housing in cylinder block |
13 - | Joint mouth |
14 - | To coolant expansion tank |
q | Coolant hose schematic diagram → Chapter |
15 - | Coolant pipe |
q | Coolant hose schematic diagram → Chapter |
16 - | Coolant thermostat: |
Adjustment margin |
q | long thermal element 87…102 °C |
q | short thermal element 103…120 °C |
q | Do not interchange when installing |
17 - | 5 Nm |
18 - | From top of radiator |
q | Coolant hose schematic diagram → Chapter |
19 - | To radiator, down |
q | Coolant hose schematic diagram → Chapter |
|
1 - | Coolant pump |
q | removing and installing → Chapter |
q | Check for ease of movement |
q | With seal incorporated |
q | Completely replace in case of fault or leakage |
2 - | Bolt |
q | 10 Nm |
q | 4x |
3 - | Bolt |
q | 20 Nm |
q | 3 off |
4 - | Pulley |
q | Use water pump wrench -V.A.G 1590- or counterhold -T10172- to loosen and tighten |
q | Locate counterhold -T10172- → Anchor |
q | -V.A.G 1590- Modify → Chapter |
q | Note location when installing |
q | Poly-V belt: removing and installing → Chapter |