–
| Place adapter -10 - 222 A /8- behind bend -2-. |
Note Plenum chamber cover is in contact with adapters -10 - 222 A /8-. |
–
| Hook support bracket -10-222 A- into right suspension eye only. |
–
| Set the crankshaft to the TDC for cylinder 1. Then turn the crankshaft back about 45° against the direction of rotation of the engine and remove the camshaft sprockets together with the timing chain → Chapter. |
–
| Remove ignition coils. To do so, use the socket -T10094 A- → Chapter. |
–
| Remove cable guide of wiring harness from camshaft housing. |
–
| Loosen camshaft housing bolts from outside to inside, alternately and diagonally and remove. |
–
| Carefully lift camshaft housing off. |
|
|
|