Insert pressing the sealing flange with the sender wheel onto the crankshaft |
Note t
| The sealing flange with the PTFE seal is fitted with a pressure ring on the sealing lip. This pressure ring fulfils the function of an assembly sleeve and cannot be removed before fitting. |
t
| Once unwrapped, do not remove the sealing flange from the sender wheel or twist them. |
t
| The sender wheel is held in its installation position on the assembly device -T10134- by a locating pin. |
t
| The sealing flange and seal are one unit. Must always be replaced along with the sender wheel. |
t
| The assembly device -T10134- is held in its position relative to the crankshaft by a guide pin inserted into a hole in the crankshaft. |
|
|
|