–
| Bring the securing tool -T20205- with the hydraulic jack -SAT 1040- and turn the bolt -4- until it is parallel with the engine block. |
–
| From the rear of the engine -A-, first insert the fixed column -1-, then adjust the mobile column -2- as necessary and then screw on the nuts -arrows-. |
–
| From the front of the engine -B-, position the mobile column -6- and adjust the bolt -5-. |
–
| Adjust the bolt -3- to immobilise the securing tool -T20205-. |
Note To unscrew the bolts for gearbox mounting use the step ladder. |
|
|
|