Leon Mk2
|
| 1 - | Joint mouth |
| 2 - | O-ring |
| q | Replace |
| 3 - | Compression spring |
| 4 - | Coolant temperature sender -G62- |
| q | Before removing, reduce cooling system pressure if necessary |
| 5 - | Plunger |
| q | Do not confuse during assembly |
| 6 - | Clip |
| q | Ensure correct seating |
| 7 - | 10 Nm |
| 8 - | Thermostat housing |
| 9 - | Oil seal |
| q | Replace |
| 10 - | To the heat exchanger |
| q | Coolant hose schematic diagram → Chapter |
| 11 - | Comes from heat exchanger |
| q | Coolant hose schematic diagram → Chapter |
| 12 - | Coolant pump housing in cylinder block |
| 13 - | Joint mouth |
| 14 - | To the expansion tank |
| q | Coolant hose schematic diagram → Chapter |
| 15 - | Coolant pipe |
| q | Coolant hose schematic diagram → Chapter |
| 16 - | Coolant thermostat: |
| Adjustment margin |
| q | Long thermoelement 87...102 °C |
| q | Short thermoelement 103 °C...120 °C |
| q | Do not confuse during assembly |
| 17 - | 5 Nm |
| 18 - | Comes from the top of the radiator |
| q | Coolant hose schematic diagram → Chapter |
| 19 - | To radiator by the bottom part |
| q | Coolant hose schematic diagram → Chapter |
|
| 1 - | Coolant pump |
| q | Removing and installing → Chapter |
| q | Check for ease of movement |
| q | With integrated seal |
| q | Completely replace in case of fault or leakage |
| 2 - | 10 Nm |
| 3 - | 20 Nm |
| 4 - | Belt pulley |
| q | To loosen and tighten, use the water pump wrench -V.A.G 1590- |
| q | -V.A.G 1590- Adapt the → Chapter |
| q | Note the attachment when fitting |
| q | Poly-V belt: Removing and installing radio → Chapter |
