Secure the fitting device -T10134- to the crankshaft flange; to do so, tighten the Allen bolts -A- about
–
Tighten both Allen bolts by hand.
–
Move the fitting device -T10134- by hand onto the sealing flange.
–
Tighten the hexagonal bolt -E- on the threaded spindle until it comes into contact with the installation bell -C-.
–
Tighten the hexagon nut of the installation device -T10134- using the torque wrench -V.A.G 1331- and the insert e/c 24 terminal -V.A.G 1332/11- to 40 Nm.
–
Check the fitting position of the sender crown on the crankshaft once more. → Chapter
If distance -A- is still too small:
–
Tighten the hexagonal bolt of the assembly device -T10134- to a torque of 45 Nm.
–
Check the fitting position of the sender wheel on the crankshaft once more → Chapter