seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Mixture preparation system, electronic inj.,Gas > < Assembly overview
Fuel tank venting: verification
Fuel tank venting: verification
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Manual vacuum pump -VAS 6213-, see equivalent → Anchor
Test requirements
l  Ignition must be switched off.
Checking procedure
  W00-10259
–  First remove the active carbon filter breather hose -1- from its connection to the active carbon filter solenoid 1 -N80--2-.
–  Connect to hose -1- the manual vacuum pump -VAS 6213- as shown in the figure.
–  Operate the manual vacuum pump -VAS 6213- a few times. Vacuum must not build up.
If a vacuum builds up:
–  Check breather connection -3- located on bottom of active carbon filter -4- for soiling; clean if necessary.
If a vacuum does not build up:
–  Temporarily seal breather connection -3- and operate vacuum pump again several times. A vacuum must build up.
If a vacuum does not build up:
–  Renew active carbon filter.
  N20-10130

Mixture preparation system, electronic inj.,Gas > < Assembly overview