SEAT Workshop Service and Repair Manuals > Leon Mk2 > Power unit | 4 cylinder injection engine (1.6l 4V, Chain control) | Fuel supply, gas operation | Fuel supply system components | Fuel gauge sender G : Removing and fitting

Fuel gauge senderG: Removing and fitting

Fuel gauge sender -G-: Removing and fitting

Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter

Special tools and workshop equipment required

t	Wrench -T20207-, see equivalent → Anchor

t	Torque wrench (40 - 200 Nm) -V.A.G 1332-, see equivalent → Anchor

Removing

–	Remove fuel delivery unit → Chapter.

–	Push the fuel level sender -G- slightly inwards in the -direction of the arrow- and at the same time remove upwards in the -direction of the arrow-.

–	Unlock the connector tabs -1 … 3-, inserting a fine screwdriver through the holes -arrows- and disconnect the connectors.

Fitting

Installation is carried out in the reverse order. When installing, note the following:

Fitting position for fuel level indicator sender -G- cables

I -	Brown Cable

II -	Blue Cable

III -

Black Cable

Note

When mounting the fuel level sender -G- on the supply unit, make sure that the cables are correctly positioned.

–	Insert the fuel gauge sender -G- into the guides on fuel delivery unit and press upwards until it clicks into place.

–	Insert connector and check they have engaged properly.

–	Install fuel delivery unit → Chapter.

SEAT Workshop Service and Repair Manuals