seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Throttle control unit J338 : cleaning > < Air filter - assembly overview

Leon Mk2

Air filter housing: Removing and fitting
Air filter housing: Removing and fitting
Removing
   
–  Press the tabs -arrows- and remove the air intake hose from the air intake duct.
  N24-10322
–  Disconnect the hose -1- from the retention valve.
–  Pull the air filter housing up, removing it from the support pins -2-.
Fitting
Install in reverse order. Note the following:
  Note
t  To attach the upper body of the air filter housing onto the lower one and the suction inlet, use a set of self tapping screws. If these screws are loosened or tightened with a screwdriver, the thread of the upper element of the air filter may be damaged.
t  For this reason a screwdriver can only be used when:
t  The power tool maximum speed is 200 rpm.
t  Max. tightening torque of 3 Nm
  N24-10323
–  Push the air filter upwards removing it from the bracket bolts -2-.
–  Connect the hose -1- to the retention valve.
  N24-10323
–  Fit the air intake hose on the air intake duct until the clips snap into place -arrows-.
  N24-10322

Throttle control unit J338 : cleaning > < Air filter - assembly overview