SEAT Workshop Service and Repair Manuals

Coolant temperature sender -G62-: Removing and installing Removing: l  Engine cold. –  Remove the air filter housing → Chapter.

–  Release hose clip -2-. –  Remove bolt -4-. –  Unplug electrical connector -arrow-. –  Remove noise insulation → Bodywork, exterior fitting work; Rep. gr.50

–  Remove charge air hose -A- and seal charge air cooler with a clean cloth.

–  Remove bolt -1- and take out air pipe downwards.

–  Disconnect electrical connection -1- on throttle valve control unit -J338-. –  Unscrew bolts -arrows- and remove throttle valve module -J338-.

–  Remove support for intake manifold (remove nut -2- and bolt -1-).

–  Unplug electrical connector -1- at coolant temperature sender -G62-. –  Detach retaining clip (press release tabs -arrows-). –  Pull out coolant temperature sender -G62-.   Note Insert new coolant temperature sender -G62-, with 0-ring, immediately into union to avoid loss of coolant. Installing: Installation is carried out in the reverse order; noting the following in the process: t  Renew O-ring. t  After completing repair: check coolant level.