seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Active charcoal tank system > < Accelerator pedal module - Assembly overview
Removing and installing accelerator module
Removing and installing accelerator module
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  For left-hand drive vehicles: Assembly tool -T10238-
Or
  W00-10110
t  For right-hand drive vehicles: Assembly tool -T10240-
  W00-10108
Removal:
–  Remove the steering column cover -arrows-.
  A20-1085
–  Remove the cap -3- by levering with a screwdriver.
–  Undo the securing bolt -2-.
–  Unlock the terminal connector -1--arrow- and remove from the accelerator pedal module.
  N20-10509
–  Insert the release tool -T10238- (for right-hand drive vehicles, release tool -T10240-) all the way into the corresponding holes, as shown, and remove the accelerator pedal module.
Installing
  N20-10056
–  Fit terminal connector -1- to accelerator pedal module -4-. Engage the connector -arrow-.
–  Insert the accelerator pedal module onto the attachment bolts -5-.
–  Insert the centring pin -6- into the hole in the vehicle floor.
–  Secure the accelerator pedal module with bolt -2- and fit cap -3-.
  N20-10509
–  Place the steering column cover back on.
Tightening torque
  A20-1085
PartNm
Accelerator pedal module on the bodywork.10

   

Active charcoal tank system > < Accelerator pedal module - Assembly overview