Ignition System Repairs: Assembly Overview + Maintenance Guide
Note
|
| 1 - | Ignition cable |
| q | 4…8 kΩ |
| q | With suppression connector and spark plug connector |
| q | Make sure it does not have any interruptions. |
| q | Disconnect the spark plug hood off with extractor -T10112- . |
| 2 - | Ignition transformer -N152- |
| q | Marked for ignition cables: A = cylinder 1, B = cylinder 2, C = cylinder 3, D = cylinder 4 |
| 3 - | 10 Nm |
| 4 - | Electrical connector |
| q | Four-pin |
| q | for ignition transformer -N152- |
| 5 - | Spark plug, 25 Nm |
| q | Type and spark gap → Chapter |
| q | To remove and install pull off the plug connectors for the outer injectors |
| q | Remove and install with the spark plug spanner -3122 B- |
| 6 - | 2 pin connector |
| q | For the knock sensor I -G61- |
| q | Gold plated contacts |
| 7 - | 20 Nm |
| q | Tightening torque influences functions of knock sensor |
| 8 - | Knock sensor I -G61- |
| q | Gold plated contacts |
| 9 - | 10 Nm |
| 10 - | Hall sender -G40- |
| q | Gold plated contacts |
| q | Installation location: in the cylinder head, below the throttle valve module -J338- → Item |
| 11 - | Electrical connector |
| q | for Hall sender -G40- |
| q | Gold plated contacts |
| 12 - | O ring |
