Leon Mk2
Assembly overview - intake manifold with attachments |
1 - | Intake manifold pressure sender -G71- with intake air temperature sender -G42- |
2 - | 3 Nm |
3 - | O ring |
q | If this is damaged, replace it |
4 - | Intake manifold (top section) |
q | With intake manifold change-over |
q | Will be removed and installed together with the intake manifold bottom part |
5 - | Seal |
q | Replace in case of damages |
6 - | Throttle valve control mechanism -J338- |
q | With activation of the throttle valve control for electric accelerator control -G186-, angle senders 1 for throttle valve control with electric accelerator control -G187- and angle sender 2 for throttle valve control with electric accelerator control -G188- |
7 - | 8 Nm |
8 - | 15 Nm |
9 - | Rubber bearing |
10 - | 8 Nm |
11 - | Support |
12 - | Seal |
q | Replace in case of damages |
13 - | Intake manifold lower part: |
q | Removing and installing → Chapter |
14 - | Seal |
q | replace |
15 - | 25 Nm |
16 - | 25 Nm |
17 - | 3 Nm |
18 - | Vacuum hose |
q | for the vacuum switch |
19 - | Variable intake manifold change-over valve -N156- |
20 - | Vacuum hose |
q | To vacuum chamber on intake manifold |