Leon Mk2
| Ignition system: disassembly and assembly |
| 1 - | Connector |
| q | Black, 4-pin |
| q | For the ignition coil |
| 2 - | 10 Nm |
| 3 - | With ignition coils -N- and -N128- |
| q | With final power stage -N152- |
| q | With signalisation for ignition cables: |
| q | A = Cylinder 1 |
| q | B = Cylinder 2 |
| q | C = Cylinder 3 |
| q | D = Cylinder 4 |
| q | Verification → Chapter |
| 4 - | Ignition cable |
| q | With anti-parasite connector and spark plug cap |
| q | Ensure signal continuity |
| 5 - | Spark plug cap |
| q | Remove using the -T10029- tool |
| 6 - | Spark plug, 30 Nm |
| q | Remove and fit using the spanner -T20175- |
| q | Test data → Chapter |
| 7 - | Hall sender -G40- |
| q | With support |
| q | Verification → Chapter |
| 8 - | Cogwheel for camshaft |
| q | With obturation ring for the hall sender -G40- |
| 9 - | 100 Nm |
| q | Use retention tool -T20018A- to loosen and tighten |
| 10 - | 10 Nm |
| 11 - | 20 Nm |
| q | Tightening torque influences the function of the knock sensor |
| 12 - | Knock sensor 1 -G61- |
| q | Gold plated contacts on the sensor and the connector |
| q | Verification → Chapter |
| 13 - | Connector |
| q | For the knock sensor 1 -G61- |
| q | Two contacts |
| q | Contacts gold plated |
| 14 - | 20 Nm |
| q | Tightening torque influences the function of the knock sensor |
| 15 - | Knock sensor 2 -G66- |
| q | Gold plated contacts on the sensor and the connector |
| q | Verification → Chapter |
| 16 - | Connector |
| q | For the knock sensor 2 -G66- |
| q | Two contacts |
| q | Contacts gold plated |
