seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Crankshaft: disassembly and assembly > < Removing and installing dual-mass flywheel

Leon Mk2

Removing and installing drive plate
Removing and installing drive plate
t  Removing → Anchor
t  Fitting → Anchor
Special tools and workshop equipment required
   
t  Counterhold tool -T20064-
t  Depth gauge
  W00-2345
Removing
–  Attach the counterhold -T20064- to the drive plate.
–  Loosen the bolts holding the drive plate.
  E13-0019
Installing
–  Fit the drive plate using the washer with recesses -1-.
–  Insert new bolts -3- and tighten to a torque of 30 Nm.
  A13-0563
–  Check dimension -a- in 3 points and calculate the average.
t  Specification: 19,5 ... 21.1 mm.
  Note
The measurement is made through the hole of the drive plate to the bored surface of the cylinder block.
If specification is not obtained:
  A13-0564
–  Remove the drive plate again and use the compensation washer -2-. Tighten the bolts again -3- to a torque of 30 Nm.
  A13-0563

Crankshaft: disassembly and assembly > < Removing and installing dual-mass flywheel