Leon Mk2
Note
|
| 1 - | 90 Nm + further 1/4 (90°) |
| q | Replace |
| q | Do not lubricate with oil |
| q | Use locking spanner -T20018B- to loosen and tighten → Fig. |
| 2 - | Crankshaft sprocket |
| q | There should be no oil on the contact surface between the notched belt sprocket and the crankshaft |
| q | Fitting is only possible in one position |
| 3 - | 15 Nm. |
| 4 - | Seal |
| q | replace → Chapter |
| q | Do not lubricate with oil |
| 5 - | Front sealing flange: |
| q | Must be housed correctly in the dowel sleeves for adjusting |
| q | Removing and installing → Chapter. |
| q | For removing and installing, detach the oil sump → Chapter |
| 6 - | cylinder block |
| q | Crankshaft - Components overview → Chapter |
| q | Piston and conrod - Components overview → Chapter |
| q | Lubrication system - General components overview → Chapter |
| 7 - | 60 Nm + further 1/4 (90°) |
| q | Replace |
| 8 - | Dual mass flywheel or drive plate |
| q | Removing and installing dual-mass flywheel → Chapter. |
| q | Drive plate: removing and installing → Chapter |
| q | Fitting is only possible in one position - holes out of phase- |
| 9 - | Intermediate plate |
| q | Must be housed correctly in the dowel sleeves for adjusting |
| q | Do not damage or bend when assembling. |
| q | Is fitted onto sealing flange → Fig. |
| 10 - | Crankshaft sealing flange, on the flywheel side: |
| q | Removing and installing → Chapter. |
| q | Always replace completely |
| q | For fitting; use the guide socket supplied for assembly or the guide socket -T20097- |
| q | For removing and installing, detach the oil sump → Chapter |
| q | Do not apply oil or grease to the seal |
| q | Before fitting, clean the remains of oil on the crankshaft journal using a clean cloth. |
| q | The guide sleeve should only be removed after fixing the sealing flange on the crankshaft journal |
|
|
