Leon Mk2
| Intake manifold - Component overview |
| 1 - | Vacuum hose |
| 2 - | Vacuum vessel |
| 3 - | 10 Nm |
| 4 - | Exhaust gas recirculation system |
| 5 - | Vacuum hose |
| q | With non-return valve |
| 6 - | Crankshaft ventilation hose |
| 7 - | O ring |
| q | If this is damaged, replace it |
| 8 - | Support |
| 9 - | 8 Nm |
| 10 - | Throttle valve control mechanism -J338- |
| q | Engine BLY, BLR: Heating using coolant |
| q | With activation of the Throttle valve control(electric accelerator control) -G186-, Angle senders -1- for throttle valve control (electric accelerator control) -G187- and Angle sender-2- for throttle valve control (electric accelerator control) -G188- |
| q | → Fig. |
| q | adapt to engine control unit after renewing → Vehicle diagnostic, testing and information system VAS 5051 |
| 11 - | Connection for vacuum installation |
| 12 - | O ring |
| q | If this is damaged, replace it |
| 13 - | Intake manifold pressure sender -G71- with air intake temperature sender -G42- |
| 14 - | 5 Nm |
| 15 - | O ring |
| q | If this is damaged, replace it |
| 16 - | 10 Nm |
| 17 - | Rubber mount |
| 18 - | Intake manifold support |
| 19 - | 15 Nm |
| 20 - | 25 Nm |
| 21 - | O ring |
| q | If this is damaged, replace it |
| 22 - | O ring |
| q | If this is damaged, replace it |
| 23 - | Revolving distribution cylinder for the variable intake manifold change-over |
| 24 - | 10 Nm |
| 25 - | Cap |
| 26 - | Variable intake manifold change-over valve -N156- |
| 27 - | Variable intake manifold change-over element |
| q | check → Chapter |
| 28 - | Intake manifold change-over: |
| removing and installing → Chapter |
| 29 - | Connection to the Solenoid valve 1 for active carbon filter unit (pulsed) -N80- |
