Leon Mk2
Timing belt mechanism, list of components. |
1 - | Upper protection element for the notched belt |
2 - | 100 Nm |
3 - | 25 Nm |
4 - | Camshaft wheels |
5 - | Hub |
q | With generator wheel |
q | Use counterhold tool -T10051- to loosen and tighten. |
q | To remove, use puller -T10052A-. |
q | Removing and installing → Chapter |
6 - | 10 Nm |
q | Replace |
7 - | Stud |
q | 15 Nm |
8 - | Toothed belt cover (rear) |
9 - | 25 Nm |
10 - | Sleeve |
q | Replace if damaged |
11 - | 20 Nm + 45° (1/8 turn) |
q | Use the correct tightening torque to avoid damages to the engine. |
12 - | Tensioning roller |
13 - | 20 Nm |
14 - | Idler roller |
15 - | Coolant pump |
q | Removing and installing → Chapter |
16 - | Crankshaft sprocket |
17 - | 120 Nm + 90° (1/8 turn) |
q | Replace |
q | Use counterhold tool -T20018B- to loosen and tighten. |
q | Do not additionally oil or grease the threads and shoulder |
q | Tightening can be done in several stages |
18 - | 15 Nm |
19 - | Notched belt guard - lower part |
20 - | Belt pulley and vibration damper |
q | Can only be installed in one position. Holes are off-set |
21 - | 10 Nm + 90° (1/8 turn) |
q | Replace |
22 - | Cover |
23 - | Notched belt |
q | Mark direction of rotation before removing. |
q | Check for wear |
q | Do not kink |
q | Removing and installing → Chapter |
24 - | 40 Nm +1/2 turn further (180º) |
q | Replace |
25 - | Notched belt guard - centre part |
26 - | Engine mounting |
Different procedures: |
q | Small engine support foot → Fig. |
q | Large engine support foot → Fig. |
|
1. phase |
| ||
2. phase |
| ||
3. phase |
|
|
1. phase |
| ||
2. phase |
| ||
3. phase |
|