seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine cooling > < Removing and installing oil filter bracket with oil cooler

Leon Mk2

Oil pressure and oil pressure switch: check
Oil pressure and oil pressure switch: check
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
   
Special tools and workshop equipment required
t  Oil pressure tester -VAG 1342-, see equivalent → Anchor
t  Voltage tester -VAG 1527B-, see equivalent → Anchor
t  Auxiliary cable kit -VAG 1594C-, see equivalent → Anchor

Test prerequisites
l  The oil level is correct.
l  Engine oil temperature, approx 80 ℃.
Checking sequence
  Note
Checking operation of and servicing visual and acoustic oil pressure gauge → Current flow diagrams, Electrical fault finding and Fitting locations. Fault finding guide with VAS 5051
   
–  Disconnect electrical connection -arrow-fromoil pressure switch -F1-.
–  Remove oil pressure switch -F1-.
  A17-0347
–  Screw the oil pressure tester -VAG 1342- into the hole for oil pressure switch.
–  Screw oil pressure switch -2- into oil pressure tester -VAG 1342-.
–  Connect brown wire -1- of tester to earth (-).
–  Connect voltage tester -VAG 1527B- with auxiliary cables from the auxiliary cable kit -VAG 1594C- to positive of battery (+) and to oil pressure switch.
The diode should not light.
–  If the LED lights up, replace oil pressure switch -F1-.
–  Start engine and increase revolutions slowly.
–  The LED should light up between 0.55 ...0.85 bar of overpressure; if not replace oil pressure switch -F1-.
–  Increase engine speed further. At 2000 rpm and an oil temperature of 80°C, the oil must have a min. pressure of 2.0 bar.
At a higher engine speed, the oil pressure should not rise above 7.0 bar; if so remove the oil pump → Chapter and check the discharge valve.
  A17-0025

Engine cooling > < Removing and installing oil filter bracket with oil cooler