Leon Mk2
| Exhaust pipe front section with particle filter - Components overview |
| 1 - | 8 Nm |
| 2 - | Pressure sensor 1 of exhaust gases -G450- |
| 3 - | Spring retainer |
| q | For pressure reading pipes at particle filter entrance |
| 4 - | 10 Nm |
| 5 - | Pressure reading pipe at particle filter entrance, 45Nm |
| 6 - | Lambda sensor before catalytic converter -G39- 52 Nm |
| q | Removing and installing → Chapter |
| q | Grease only thread with high-temperature paste -G 052 112 A3-. The paste must not get into the slots on the probe body. |
| q | To remove and install use the lambda probe ring spanner -3337- |
| 7 - | Exhaust gas temperature sender 2, bank 1 -G448-, 45 Nm |
| q | Grease the thread of the sensor with paste for high temperature bolts -G 052 112 A3- |
| 8 - | Particle filter |
| 9 - | Exhaust tube, front |
| 10 - | Mark |
| q | Installation position of double clamp |
| 11 - | To primary silencer |
| 12 - | 25 Nm |
| 13 - | Suspension |
| q | Replace if damaged |
| 14 - | Temperature sensor after particulate filter -G527-, 45 Nm |
| q | Grease the thread of the sensor with paste for high temperature bolts -G 052 112 A3- |
| 15 - | From turbocharger |
| 16 - | Securing clip, 7 Nm |
| 17 - | Seal |
| q | Replace |
| q | Note fitting position: |
| 18 - | 40 Nm |
| 19 - | Spring retainer |
| q | Bolted to engine block |
|
|
