SEAT Workshop Service and Repair Manuals

Charge air cooler: Removing and installing. t  Removing → Anchor t  Installing → Anchor t  Tightening torques → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Torque wrench kit -SAT 8010-, see equivalent → Anchor

t  Centre guide -T10093-, see equivalent → Anchor t  Support benches

Removing –  Remove central noise insulation -Attachment parts 1 ... 3-. –  Unscrew the left and right hand side air pipes of the intercooler. –  Place the lock carrier plate into service position without mechanical components: →  Bodywork, exterior fitting work ; Rep. gr.50. –  Remove the coolant radiator → Chapter.   WARNING The air conditioning refrigerant circuit must not be opened.

–  Undo the bolts -1- from the lock carrier plate to the intercooler.   Note To avoid damage to the refrigerant pipes/hoses, take care not to strain, kink or bend pipes and hoses.

–  Unscrew the condenser bracket bolt -arrow-.

–  Remove securing bolts -2- of condenser. –  Pull the radiator out upwards. Installing Continue the installation in the reverse order of removal sequence, observing the following: –  Fit the supercharger air system hoses and observe the assembly instructions → Chapter. Tightening torques

Component	Nm
Intercooler to the lock carrier plate	5
Condenser to the intercooler	5