seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Coolant thermostat: removing and fitting > < Coolant: draining and filling

Leon Mk2

Coolant pump: removing and fitting
Coolant pump: removing and fitting
t  Removing → Anchor
t  Fitting → Anchor
t  Tightening torque → Anchor
Removing
–  Drain coolant → Chapter.
–  Remove the notched belt: vehicles with small engine support → Chapter; vehicles with large engine support → Chapter
   
–  Unscrew securing bolts -1- of the coolant pump and take coolant pump -2- off.
–  Remove O-ring -3-.
Fitting
Installation is carried out in the reverse order of removing, when doing this note the following.
  Note
Replace the O-ring.
–  Clean or smoothen the contact surface for O-ring.
–  Lubricate new O-ring -3- with coolant additive “G12+”.
–  Fit coolant pump -2-.
l  Fitting position: The housing cover cap points downwards.
–  Tighten coolant pump bolts -1-.
–  Install the toothed belt (adjusting valve timing): vehicles with small engine support → Anchor; vehicles with large engine support → Anchor
–  Install poly V-belt → Chapter.
–  Fill up coolant → Chapter.
Tightening torque
  A19-0084
ComponentNm
Coolant pump to cylinder block15

   

Coolant thermostat: removing and fitting > < Coolant: draining and filling