SEAT Workshop Service and Repair Manuals

Radiator fan -V7- and fan 2 of the radiator -V177-: removing and fitting t  Removing → Anchor t  Fitting → Anchor t  Specified torques → Anchor.

Removing Engine cover, version 1: –  Take out the oil dipstick -1- from its guide tube. –  Lift the engine cover on one side -arrows 2- and remove it forwards -arrow 3-. –  Replace the oil dipstick in the guide tube.

Engine cover, version 2: –  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards.

All vehicles (continued): –  Unplug electrical connector -2- at air mass meter -G70-. –  Disconnect the breather hose -1- and the air conduit hoses -3- and -5-. –  Screw out bolt -4- and detach air cleaner housing.

–  Bring lock carrier into service position: → Bodywork, exterior assembly work; Rep. Gr.50 –  Remove the front air conduit with the air hose; to do this, lift the retaining clips -1-.

–  Unplug connector -1-. –  Unscrew bolts -arrows- and take fan cowl out.

–  Unplug connector -1-. –  Lay bare cables. –  Unscrew nuts -arrows- and take radiators out. Fitting Installation is carried out in the reverse order of removing, when doing this note the following.   Note Replace the seal. –  Fit the charge air system lines, follow the instructions during this → Chapter. Specified torques .

Component	Nm
Radiator fan to fan cowl	5
Fan cowl to radiator	5