Leon Mk2
Exhaust system: component overview |
1 - | Rear tube bridge |
2 - | Middle silencer |
q | In case of repairs, replace the factory fitted end silencer as one part |
q | Cutting point → Chapter |
q | Fit and align exhaust system free of stress → Chapter. |
3 - | Mounting |
q | If this is damaged, replace it |
4 - | Suspension |
q | If this is damaged, replace it |
5 - | 23 Nm |
6 - | Suspension |
q | If this is damaged, replace it |
7 - | Securing clip - 7 Nm |
8 - | Seal |
9 - | Primary exhaust pipe |
q | With catalytic converter |
q | Protect from damage by knocks and impact |
q | With flexible connection (de-coupling element) |
q | Do not bend flexible connection more than 10° - otherwise it can be damaged |
q | Removing and fitting → Chapter |
q | Fit and align exhaust system free of stress → Chapter. |
10 - | Brace |
11 - | 40 Nm |
12 - | 40 Nm |
13 - | Front clamp |
q | Align exhaust system so it is free of stress before tightening clamp → Chapter |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
14 - | 25 Nm |
15 - | Front tube bridge |
16 - | 23 Nm |
17 - | 23 Nm |
18 - | Mounting |
q | If this is damaged, replace it |
19 - | Rear clamp |
q | For separate replacement of centre and rear silencers |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
20 - | 25 Nm |
21 - | Mounting |
q | If this is damaged, replace it |
22 - | Secondary silencer |
q | In case of repairs, replace the factory fitted middle silencer as one part |
q | Cutting point → Chapter |
q | Fit and align exhaust system free of stress → Chapter. |
23 - | Suspension |
q | If this is damaged, replace it |
24 - | 23 Nm |
25 - | 23 Nm |
|
|