Leon Mk2
Exhaust gas turbocharger : removing and installing - Assembly overview, vehicles with engine code BMN |
1 - | 10 Nm |
2 - | Retainer |
3 - | Heat shield |
4 - | Oil supply hose |
q | Towards the oil supply tubing coupling sleeve in the turbocharger |
5 - | Turbocharger |
q | With charge pressure actuator position sender -G581- |
q | Only replace completely with the exhaust manifold |
q | Removing and fitting: Vehicles with front-wheel drive → Chapter, vehicles with four-wheel drive → Chapter. |
6 - | Vacuum hose |
q | Of the supercharger electronic pressure limiter valve -N75- |
7 - | Seal |
q | Replace. |
q | Note fitting position: |
8 - | To the particle filter |
9 - | Clamp, -7 Nm |
q | For turbocharger/particle filter |
10 - | Exhaust manifold |
q | Replace only with turbocharger |
11 - | 25 Nm |
q | Replace. |
12 - | Connecting pipe |
q | To the exhaust gas recirculation radiator |
13 - | Seal |
q | Replace. |
14 - | 25 Nm |
q | Replace. |
15 - | 25 Nm |
16 - | 15 Nm |
17 - | O ring |
q | Replace. |
18 - | Gapped screw -60 Nm |
19 - | Retainer |
q | For the exhaust gas turbocharger |
q | with oil backflow tube |
20 - | Exhaust gas temperature sender 1 -G235-, 45 Nm |
q | Removing and fitting → Chapter |
q | Grease the thread of the sensor with hot screw paste; Hot screw paste → Spares catalogue |
q | Installation position of exhaust gas temperature sender using the angled pin → Fig. |
21 - | Heat shield |
22 - | 25 Nm |
q | Replace. |
23 - | Joint mouth |
q | For air / turbocharger flexible hose |
24 - | 9 Nm |