Leon Mk2
Ignition system components removal and installation |
1 - | Spark plug wire |
q | With suppression connector and spark plug connector |
q | Resistance 4.8...7.2 KΩ |
q | Check for continuity |
2 - | Ignition transformer -N152- |
q | Marked for H.T. |
A = Cylinder 1 |
B = Cylinder 2 |
C = Cylinder 3 |
D = Cylinder 4 |
q | Check → Chapter |
q | Fitting location → Chapter, engine compartment overview |
3 - | Connector |
q | Black, 4-pin |
q | For ignition transformer -N152- |
4 - | 10 Nm |
5 - | Connector |
q | Black, 2-pin |
q | For knock sensor 1 -G61- |
q | Sensor and connector contacts are gold-plated |
6 - | Knock sensor 1 -G61-* |
q | Checking → |
q | Fitting location → Chapter, engine compartment overview |
7 - | 20 Nm |
q | Tightening torque influences the function of the knock sensor |
8 - | Connector |
q | Black, 3-pin |
q | For Hall sender -G40- |
9 - | Hall sender -G40-* |
q | Check → Chapter |
q | Fitting location → Chapter, engine compartment overview |
10 - | O-ring |
q | Renew if damaged |
11 - | Spark plug, 30 Nm |
q | Remove and install with spark plug spanner -T20028- |
q | Type and electrode gap → Chapter, test data, spark plugs |
12 - | H.T. cable guide |