| Location of EPC warning lamp. |
| If faults are recognised in electronic accelerator system when the engine is running, the engine control unit will switch on the EPC lamp (these faults are marked in the fault table). Simultaneously an entry is made in the engine control unit fault memory. |
| –
| Switch ignition on: The EPC warning lamp should light up. |
| If the EPC warning lamp does not light up with the ignition on: |
| If the EPC warning lamp lights up with the ignition on: |
| –
| Start engine and run at idling speed: The EPC warning lamp should switch off after a few seconds. |
| If the EPC warning lamp does not switch off: |
| –
| Interrogate fault memory, if necessary, repair any faults and then erase fault memory → Chapter; interrogating and erasing fault memory. |
|
|
|
