seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Motor for plate in inlet manifold: removal and refitting > < Cleaning rules
Location of the components
   
Location of the components
Component A does not appear in the breakdown.
t  A - Accelerator pedal position transmitter -G79-
t  In the footrest area, on the accelerator pedal. Check → Rep. Gr.20.
1 - Upper element of the inlet manifold
2 - Injector
q   For cylinder 3 with needle stroke transmitter -G80-
3 - Motor for plate on inlet manifold -V157-
q   Check → Chapter
4 - Exhaust gas recirculation valve
q   Check: → Rep. Gr.20
5 - Valve for exhaust gas recirculation -N18-
q   Check → Chapter, Actuator diagnosis
6 - Relay for low calorific power -J359- and relay for high calorific power -J360-
q   Check → Chapter, Actuator diagnosis
7 - inlet manifold temperature transmitter -G72-
q   Check → Chapter
8 - Control unit of the diesel direct injection system -J248-
q   Location: in the water box
q   Check the voltage supply of the diesel direct injection system → Chapter
q   Replace → Chapter
q   Coding → Chapter
9 - Brake pedal switch
q   In footrest area, brake pedal
q   Check the signals of the brake light and brake pedal switches → Chapter
10 - Brake light switch -F-
q   In footrest area, brake pedal
q   Check the signals of the brake light and brake pedal switches → Chapter
11 - Clutch pedal switch -F36-
q   In footrest area, on the clutch pedal
q   Check the signal of the clutch pedal switch → Chapter
12 - Temperature transmitter of thecoolant -G62-
q   Black
q   For engine control unit
q   With transmitter for the coolant temperature indicator -G2-
q   Before removing, reduce the pressure of the coolant system
q   Check → Chapter
13 - 10 Nm
14 - Engine speed transmitter -G28-
q   Check → Chapter
15 - O ring
q   Replace if worn
16 - Double connector
q   Brown
q   For needle stroke transmitter -G80-
17 - Three contact connector
q   Grey
q   For engine speed transmitter -G28-
18 - 10 contact connector
q   Black
q   For fuel temperature transmitter -G81-
q   For doser -N146-
q   For stroke transmitter of the regulator slide -G149-
q   For fuel cut valve -N109-
q   For injection start valve -N108-
19 - Injection start valve -N108-
20 - Fuel cut valve -N109-
21 - Injection pump
q   With dosing servomechanism
q   With doser -N146-
q   With stroke transmitter of the regulator slide -G149-
q   With fuel temperature transmitter -G81-

   

Motor for plate in inlet manifold: removal and refitting > < Cleaning rules