| –
| Check clutch release bearing for wear, renew if necessary. |
| –
| Check centring of clutch drive plate, if necessary. |
| –
| Lightly grease clutch release bearing, release bearing guide sleeve and splines on input shaft with -G 000 100-. |
| –
| Check whether the dowel sleeves for centralising engine/gearbox are in the cylinder block, install if necessary. |
| –
| When introducing assembly, ensure that enough clearance exists between the drive shafts. |
| –
| Align engine by rocking in such a way that engine supports carry no tension. |
|
|
|
Note!
